Unijunction transistor (UJT)

Introduction to UJT

The Unijunction transistor, commonly known as UJT, is a three-terminal electronic device that can be used as a switch, oscillator, and trigger. It was first introduced by General Electric in the 1950s and has since found use in a wide range of applications. The UJT is a type of thyristor, which means that it can conduct current in one direction only, making it useful in rectification and power control applications.

Working Principle of UJT

The UJT is a two-layered semiconductor device with a lightly doped n-type material sandwiched between two heavily doped p-type materials. When a voltage is applied to the emitter terminal, it creates a forward bias between the emitter and the n-type region, causing a flow of minority carriers (electrons) into the n-type region. As the voltage increases, the minority carriers accumulate and eventually the n-type region becomes saturated, causing a drop in resistance between the two p-type regions. This is known as the UJT’s “negative resistance region”, where a small increase in current can cause a large decrease in resistance. When the voltage at the gate terminal exceeds the voltage at the emitter terminal, the UJT turns on and conducts current in the direction of the emitter to the collector.

Applications of UJT

The UJT has several applications, including relaxation oscillators, pulse generators, and timing circuits. One of the most common applications of the UJT is in the triggering of thyristors, which are used in AC power control circuits. The UJT can be used to generate a triggering pulse at a specific point in the AC cycle, which triggers the thyristor to conduct current and control the power delivered to the load. The UJT can also be used as a switch in low-power DC circuits, where its low on-state voltage drop and fast switching speed make it an ideal choice.

Example of UJT Circuit

A simple UJT relaxation oscillator circuit is shown below. The circuit consists of a UJT, a resistor, and a capacitor. When the circuit is first powered on, the capacitor charges through the resistor until the voltage at the gate terminal exceeds the voltage at the emitter terminal, causing the UJT to turn on and discharge the capacitor. As the capacitor discharges, the voltage at the gate terminal decreases until it falls below the voltage at the emitter terminal, causing the UJT to turn off and repeat the cycle. The frequency of oscillation can be adjusted by varying the values of the resistor and capacitor.

        +Vcc
         |
         R
         |
         |   +-------+
         |   |       |
         |   |       |
         |   |       |
         |   |       |
         |   |UJT   C
         |   |       |
         |   |       |
         |   |       |
         |   |       |
         |   +-------+-------
         |
         |
        GND

In conclusion, the Unijunction transistor (UJT) is a versatile electronic device that can be used as a switch, oscillator, and trigger. Its unique negative resistance region and fast switching speed make it ideal for use in thyristor triggering circuits and low-power DC circuits. With its numerous applications and simple construction, the UJT remains an important component in modern electronics.

header - logo

The primary purpose of this project is to help the public to learn some exciting and important information about electricity and magnetism.

Privacy Policy

Our Website follows all legal requirements to protect your privacy. Visit our Privacy Policy page.

The Cookies Statement is part of our Privacy Policy.

Editorial note

The information contained on this website is for general information purposes only. This website does not use any proprietary data. Visit our Editorial note.

Copyright Notice

It’s simple:

1) You may use almost everything for non-commercial and educational use.

2) You may not distribute or commercially exploit the content, especially on another website.